Ford Focus RS Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
121 Posts
Discussion Starter #1
Remember when Hennessey said they were bringing the Focus RS400 with respectively 400hp ? Apparently they made the attempt and came up with 326hp and 382lb-ft of torque in this clip of the dyno pull including chart at the end. To make matters worse, they've managed to disconnect the rear wheels in order to minimize drivetrain loss.

 

·
Registered
Joined
·
5 Posts
Through the access port - you can turn on Dyno mode, which removes the power to the rear wheels, I would imagine - if the rear wheels were powered, it would be about a 5% difference, from the front.. I don't imagine much of a difference.. So, in this case, 326FWHP, would probably yield 310-315 AWHP..
 

·
Registered
Joined
·
18 Posts
Aren't there 4-wheel dynos "out there?" Several AWD hot models that are often "tuned." STi comes to mind, and COBB has TONS of aftermarket parts for it.
 
1 - 3 of 3 Posts
Top